Router Bit Set – Bevel with Bearing
TCT Router Bits
Each router bit features diamond ground, micro-grain tungsten carbide tipped blades. This tighter micro-grain structure means the blades offer long lasting hardness and superior edge retention. The body of each bit has been turned and then milled with uncompromising precision from a single piece of 4140 high tensile steel to give perfect balance for reduced vibration and therefore smoother cuts. 4140 steel has been chosen because of its toughness, high fatigue strength, and abrasion and impact resistance. The tungsten carbide tips are then brazed onto the bodies using induction to create an extremely strong joint that safely holds under the high stresses that occur when routing. The router bits are suitable for use on softwoods, hardwoods, veneers, laminates and composite materials.
Bevel with Bearing Bits
Bevel with bearing bits are a popular choice for providing a sharp, clean bevelled edge on door and window frames, table and chair legs, windowsills, mouldings and much more. The bits can also be used to create a small chamfer on the corners of veneers and laminates which will prevent chipping. Each bit has a bearing which acts as a fence against the workpiece to ensure the profile is being followed without the use of a template. The set of 4 contains an 11.25°, a 15°, a 22.5° and a 30° bevel bit. Shanks are 1/4″.
Superior Finish and Performance
The shearing angle of the cutting edges ensure they remain in constant contact with the workpiece to allow a smoother, slicing cut which eliminates tear-out and gives a mirror finish. The bits feature right hook angles which further enhances the cut due to the fast removal of chips. These bits feature an anti-kickback design which limits the feed rate of the material being cut to decrease the likelihood of a kickback, meaning each bit conforms to strict German DIN standards to ensure maximum operator safety. ©
