Solid Carbide Router Bit – Spiral Chipbreaker Up Cut 3 Flute Discount

Solid Carbide Router Bit – Spiral Chipbreaker Up Cut 3 Flute
Solid Carbide Router Bits
Each router bit has been precision ground from a single piece of super micro-grain solid tungsten carbide. This ultimate micro-grain carbide formulation gives the longest tool life and edge retention ensuring a very clean and accurate cut that leads to the ultimate finish. These STC router bits are suitable for use on softwoods, hardwoods, veneers, plastic materials, laminates, and composite materials.

Spiral Chipbreaker Up Cut Three Flute Bits
Spiral chipbreaker up cut three flute bits provide a finer surface finish than their 2 flute counterparts, and are used for their high feed rates and low noise under load. The up-cut design pulls chips up and clear of the cutting area, typically used when the best possible finish is required on the bottom surface of a part. The notched chipbreaker profile reduces the size of the chips, providing superior chip clearance and reducing the workload on dust collection systems. The finish given by these bits may be acceptable without further finishing.

Superior Finish and Performance
Each spiral has been specifically designed to give the optimum cutting angle to ensure the wood is sheared cleanly as well as providing efficient chip ejection. This leads to the bits running cooler during use as solid carbide dissipates heat more uniformly, even at high speeds, meaning the edges remain as sharp as possible and are retained for longer. Each bit conforms to strict German DIN standards to ensure maximum operator safety. ©